Skip to main content
Skip table of contents

Powered Room Thermostat Exclude

This article is an excerpt from the Genius Hub Doctor, which is built into the App.

These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.

To access the Doctor, click here

Solution ID: 7402

Step 1

To remove the Powered Room Thermostat from the system, it needs to be powered on and in range of the Genius Hub.

To add the device, ideally this is within direct range of the Genius Hub (either in the same room as each other, or adjacent rooms).

If the devices are not close enough together:

1. Move the Genius Hub closer to the Powered Room Thermostat. The Genius Hub must have power and an Internet connection. This can be done by:

a) Using a long Ethernet cable
b) Plugging the Hub into a different Ethernet switch
c) Using a Power Line Ethernet adaptor or WiFi booster which has an Ethernet port ( see this link for how to connect the hub with a power-line Ethernet adaptor )

2. Temporarily wire the Powered Room Thermostat to a plug and short piece of flex so you can power on the Powered Room Thermostat next to the Genius Hub. It is recommended that this is done by an electrician/heating engineer.

Alternatively, click here, if the device has failed/is no longer in the property


Step 2

Now the Genius Hub needs to get ready to remove the device.

The Doctor will remove the device


Step 3

1. Press and hold the centre button until "OFF" is shown on the display.

2. Press the down button repeatedly until you reach "CON".

3. Press and hold until the middle button until display shows a rotating light pattern.


On success, the Powered Room Thermostat will display 'ECL' for a couple seconds.

The Doctor will communicate with the device


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.