Skip to main content
Skip table of contents

In Wall Meter Factory Reset

This article is an excerpt from the Genius Hub Doctor, which is built into the App.

These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.

To access the Doctor, click here

Solution ID: 7304

Step 1

Factory resetting a device removes it from any Genius Hub and removes any custom settings. It does not require a Genius Hub to power powered on/in communications range.

Ensure that the Range Extender is wired in and powered on.

The Range Extender will have to be removed from its pattress to check the connection.

Unscrew the Fused Spur or Blanking Plate from the front of the pattress.


Step 2

Press the button on the front 4 times in 1.5 seconds, and hold it on the 4th press until the light turns on and then turns off.

When the light turns off to remove your finger from the button.

If the light flashes slowly, the device has been successfully factory reset.

Click here to add the Range Extender to this Genius Hub

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.