Skip to main content
Skip table of contents

Wireless Room Thermostat (D) Exclude

This article is an excerpt from the Genius Hub Doctor, which is built into the App.

These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.

To access the Doctor, click here

Solution ID: 7752

Step 1

Remove the Room Thermostat from its backplate using a flat bladed screwdriver. Place this in the cutout in the underside of the device, before levering the front away.

Make sure that the Room Thermostat is in the same room as the Genius Hub.

Turn the Room Thermostat over, so the screen is facing away from you and pull out the plastic tab to connect the battery, or insert new batteries.



Step 2

Now the Genius Hub needs to get ready to remove the device.

The Doctor will remove the device


Step 3

Ensure the screen of the Room Thermostat is facing away from you.

Press the 'chain' link button above the battery compartment 3 times in quick succession.


Turn over to read the screen, which should be showing a circling LEDs.

On success, the Room Thermostat will show 'ECL' and will have been assigned a number, write this number on the side of the device.

The Doctor will communicate with the device

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.