This article gives procedures required to put the Single Channel Receiver into Manual only control in order to give you the ability to manually control on/off state of the Single Channel Receiver in the case the device becomes disconnected from the Genius Hub.
Step-by-step guide
- Power off the Single Channel Receiver
- Hold down both the ON and OFF buttons together
- With the buttons held down, power on the device
While the Single Channel Receiver is in Manual only control, use the ON and OFF buttons to control the relay state.
To exit Manual only control, simply power cycle the device by:
- Power off the Single Channel Receiver
- Switch on the Genius Hub
Power on the Single Channel Receiver and this will need re-including onto the system.
Using this procedure during normal operating will drastically decrease battery of devices and this is only recommended on VERY OCCASIONAL EMERGENCIES or advised by the Support team.