...
Troubleshooting step |
---|
Power on the Electric Switch* within 2 meters (line of sight) of the Genius Hub. You may need to move the Genius Hub closer to the Electric Switch, the hub needs to be both plugged into the power and also the internet, you can temporarily wire the Electric Switch to a plug and short piece of flex so you can power on the Electric Switch next to the Genius Hub. If you also have a Tank Temperature Probe, this needs to be wired in before you link the Electric Switch to the Genius Hub (this requires a 'micro flat bladed screwdriver'). *It is recommended that this is done by an electrician/heating engineer. Remove the white front cover from the Electric Switch using a flat bladed screwdriver. Push the screwdriver into the slot on the underside of the cover and flex the slot out slightly to release the white cover. |
Troubleshooting step | ||||||||
---|---|---|---|---|---|---|---|---|
Now the hub needs to get ready to add the device.
|
Troubleshooting step | ||||||||
---|---|---|---|---|---|---|---|---|
Hold down the clear plastic button located on the top left of the Electric Switch, the red LED next to the button will start to flash quickly. The flashing red light turns off when the device has included successfully. Replace the front cover back onto the Electric Switch. On success, the Electric Switch has been assigned a number, write this number on the side of the device.
*** Verification Test to ensure new node ID & hash = DCR hash *** |
Troubleshooting step | ||||||
---|---|---|---|---|---|---|
Install the Electric Switch and wire it in place if it is not already. Now you need to finish the steps here and then add the Electric Switch to a corresponding zone on the app. If controlling the main source of heating for the property, or the main circulation pump, first go to the 'Home Screen', tap on 'Setup' (under the menu ••• ), tap on 'Assign Device' at the bottom and choose the Electric Switch which is wired to the heating.
*** Assign channel 1 to zone ***If controlling electric heating or a zone of underfloor heating or anything else, go to the 'Home Screen', tap on the corresponding zone, tap on 'Zone Setup' (under the menu ••• ), tap on 'Assign Device' at the bottom and choose the Electric Switch which is wired to what you are trying to control. |