The following explains how to add a new Smart Plug to a Genius Hub.
If you have an existing Smart Plug it will need to be factory reset before it is connected to a Genius Hub. |
Plug the Smart Plug into the wall socket within 2 meters (line of sight) of the Genius Hub (and turn the socket on). The red light will flash once every second. Prepare the device to be added to the Hub by pressing and holding the button on the Smart Plug for 5 seconds.
|
The Hub needs to prepare to add the device.
|
Ready to add the new Smart Plug. Press the button and hold it down for approximately 5 seconds, at which point the light under the button will change. The box below will change to say 'Device Found' when the Smart Plug starts adding, before displaying the device ID.
|
Including the device
The device needs to be detected by the hub one more time
|
Press the clear/red button 3 times in within 1.5 seconds. The flashing red light stops flashing when the device has included successfully. On success, the Smart Plug has been assigned a number, write this number on the side of the device.
|
Now you need to finish the steps here and then add the Smart Plug to a corresponding zone on the app if you want to control when it turns on, so you can control other things such as lights.
|
|
|
Locate the Smart Plug as necessary. See the following article for further advice: Positioning the Genius Hub Smart Plugs or Range Extenders |