The following explains how to send the standard configuration messages to the Genius Room Thermostat to ensure that it is communicating correctly with the Genius Hub.


Sometimes a Genius Room Thermostat may lose the factory settings which were applied to it when it was added to the system. This can occur when the batteries have been changed in the device. When the Genius Room Thermostat has the incorrect configuration messages it can communicate with the Genius Hub too often, which leads to the batteries not lasing as long or it can not report back the measured temperature to the Genius Hub. 


First locate the Genius Room Thermostat in the room you want to adjust.

The number of the Genius Room Thermostat may be located on the side of the device




The device now needs to be configured by the Genius Hub to ensure the correct behaviour and communication.


To configure the device:
Go to the 'Menu' then 'Settings'
Select 'Devices'
Select the Genius Room Thermostat you want to adjust
Click on the Device sub-menu (3 dots)
Select Configure and confirm





To ensure that the messages get through to the device, it needs to be woken up.


First, ping the device:
Select the Genius Room Thermostat in the room you want to adjust
Click on the Device sub-menu (3 dots)
Select Ping and confirm

Wake up the device by pressing the middle button once.



The Genius Room Thermostat should now receive the correct configuration parameters.


The Hub will check that the Genius Room Thermostat is reporting its Measured Temperature




The newly awakened Genius Room Thermostat should now receive the correct configuration parameters.

The Hub will check that the Genius Room Thermostat is reporting its Battery Level