The following explains how to re-add an Electric Relay to a Genius Hub.
If this is an existing Electric Relay it will need to be factory reset, as per these instructions. |
Power on the Electric Relay* within 2 meters (line of sight) of the Genius Hub. You may need to move the Genius Hub closer to the Electric Relay, the hub needs to be both plugged into the power and also the internet, you can temporarily wire the Electric Relay to a plug and short piece of flex so you can power on the Electric Relay next to the Genius Hub. *It is recommended that this is done by an electrician/heating engineer. |
Now the Genius Hub needs to get ready to add the device.
|
Press the white button located on the front of the Electric Relay 3 times in 1.5 seconds, the red LED inside the device will start to flash quickly.
The flashing red light turns off when the device has included successfully. On success, the Electric Relay has been assigned a number, write this number on the device.
|
Now pick a zone to assign the Electric Relay to.
|
|
|
Install the Electric Relay and wire it in place if it is not already. We recommend using a 40mm backbox. |
Now the device is confirmed as no longer on the system, it can be removed.
|