In Sense mode, you can set up a 7-day schedule to control the heating in this zone, in a similar manner to Timer mode. You set up a ‘heating period’ to suit your needs, including start time, end time, temperature, along with whether you want the period to switch on regardless or only when someone is in the zone.
The main difference between Timer mode in Radiator, Underfloor heating or Hot Water Temperature zones compared with On/Off zones is that you can set a temperature for these types of zone. In On/Off zones you can only set periods where the heating is on or off.
The 'react to occupancy' will only work in zones with a Room Sensor, or Occupancy Trigger channel assigned to them. |
To view the schedule for any zone:
Periods which will react to occupancy are shown by an underline on the timerbars, and indicated by a motion symbol next to the times and temperature when editing timer periods.
If you wish to view a day's schedule in more detail, click on the day you wish to view. This will load the details of the heating schedule including the default temperature and a list of the heating periods.
For a reactive heating period:
For a non-reactive heating period (or default period):
Sense mode is currently available for free during its BETA phase. |
To use Sense Mode
With the Genius Hub system you can set as many heating periods as you require throughout the day.
Each timer period must be a minimum of 5 minutes, however there are no other limits on the number of periods you can create. |
To add a timer period for a heating zone:
Select when the heating period should begin, by first clicking on the hour the heating period will begin.
Next click on the minutes the heating period should begin, followed by Set.
If you want to change the hours the heating period starts at, click on the hours at the selected time. |
For an On/Off zone, the period will automatically be set to 'ON', and this cannot be changed. |
If your schedule changes or the temperature in a room is not right for you, it is easy to change a Timer period.
To change a Timer period:
If your schedule has changed significantly, you may wish to delete a Timer period.
To remove a Timer period for a zone:
There is no way to recover a Timer period, so ensure you are deleting the right one. |
For those times of day which you do not want the heating on high, you can set a default temperature, so that the room doesn't cool down too far, leaving you to return to a cold house or causing the room to take a long time to heat up again. Default periods cannot be reactive. If you want a zone to react throughout the day, you will need to create timer periods to cover all of the 24 hour period.
The default temperature can be set for each day of each zone. To do this for heating zones:
Default temperatures are especially important with underfloor heating which can take a number of hours to reach the desired temperature. The reason for this is because if the floor gets too cold then it takes a very long time to warm up such as large mass, compared with a metal radiator. It is recommended that a default temperature of no less than 4°C below the normal heating temperature is selected. We also recommend you use Pre-Heat for Underfloor Heating zones. |
There is no configurable Default setting for On/Off zones. The zones are off by default and the Timer periods are always On.
An alternative way to schedule the heating in your home is to activate Pre-heat from the Zone Setup.
If you want to enable Pre-heating, please see the 'Setup pages' chapter.
For the following options, see the relevant sections of Timer Mode:
Related Information:Related articles appear here based on the labels you select. Click to edit the macro and add or change labels. |